• Place the folded table sating on the rubber huntpry., with the heel of your hand. bump the tab between the face rest outlets and the will open. table (Fig 1) • Open the table up until the legs are fully extended. Remove the face rest (Fig 2) To Set the Table Upright: • When the table is fully opened, tilt the table upright until all four arc on the feet floor. Lift one end of the table, press down on the middle and tension the cables a little. (Fig. 3) •Choose the hole that represents desired height the and after removing knob, put the the bolt through Replace that hole. and tighten until snug. the knob by hand Repeat on all other extensions, leg setting all extensions same height. at (fig.4) , • J Ser# 27 x 24- 73 Foam L PL 8/3/20 ras' 117 • Turn the table on its mate with th• rubber bumper• down a It face-tnt, lailitT it MLitt the lilt by into the clip provided (Fag Partially close the table top Fold the legs into the table and make sure the armrest is laying flat and the cables are inside of the the two halves table Push of your to lock table %twitter (Fig 6) For Tables with the Shiatsu Option: • With your table on its side. release cables from the the rings (Fig. tia) and turn the unitock clasp to the side. (Fig. • Fold lib) the legs against and the underside lay the table down flat on the (Fig.9) floor • To return to normal height see settings, the separate CAUTION label refers that to the Shiatsu Cable Option. Dynamic Load Rating: OAKWORKS®, 923 East Wellspring Rd., New Freedom, PA 17349 Toll Free Phone: 800-558.8850 Toll Phone: 717-235 Free FAX: 877-562-4787 717 235 67i EFTA01341046