t.1.43 PIA( • the t- folded table ting ra on the rubber bumpers, with heel the of hand, your bump the between tab the face outlets rest and the table )pt-o the up table until the are legs Italy extended. Remove the face rest 2) (Fig Set To Table the Upright: When • the table fully is opened, tilt the upright table all until four feet on arc the Lift floor. end one the of table, down press on middle the and tension cables the little. a 3) (Fig. *Choose hole the that represents the desired height after and removing the knob, put bolt the through hole. that Replace and tighten knob the hand by snug. until Repeat other all on kg extensions, setting extensions all at Ni Clos• To /ho table: sI 1 -, 73PLTTVN Ser# t.,VS3671 5 - LS3 :ova 24-34 x 27 PUTT/ x Ni Foam 73 L: r - • tio;?akworkst tirsnete LISTED All ponable tables: C.S S.alrl.I Pairnt Th Sideladtm • I's Pawn; ti,')„ 5,9 wood( • Palen Pint in:; Partially close the table top. Fold kid the into the table make and sure armrest the laying is and flat the cables are Inside the of Push table. the halves two your of table together to lock tiTig For tables with Shiotsu the Option: With • your on table side, its release the cables from rings the (Ftg.tta) and turn Fold • the against legs underside the and the lay down table on flat the floor (Fig.9) To • return normal to height settings, see separate the CAUTION label that refers Shiatsu the to Option. Cable Dynamic Rating: Lead OAKWORES Inc. , ® Wellspring East 923 Freedom, New Rd., 17349 PA S I Free Toll Peon Phone: FAX: Free oll FAX: T orks w Woa A1 coin . EFTA01303382